Easy Guide: Fixing the Charger Port on Asus Zenbook Duo

Table of Contents

1. Introduction
2. Tools required
3. Removing the back cover
4. Disconnecting the battery
5. Removing the main board
6. Replacing the charging port
7. Testing the device
8. Reassembling the laptop
9. Conclusion

Opening Up and Repairing an Older Zenbook Duo with a Damaged Charging Port

In today's video, we will be opening up an older Zenbook Duo that has a damaged charging port. The Current issue is that the charger can be pushed in, but it only connects for a brief moment before disconnecting again. To fix this issue, we will be replacing the charging port on the main board.

Before we begin, You will need a T4 screwdriver, a couple of flathead screwdrivers, a pair of tweezers, and a place to put the screws. There are also small Rubber feet that need to be removed before we can access the screws. These feet serve the purpose of preventing debris from entering the device. Once the feet are removed, we can proceed to remove the screws. There are six torque screws at the back and four black screws across the front.

Now that the screws are removed, we can pry open the back cover using a metal pry tool or by carefully using our nail. Once the cover is removed, we can move on to disconnecting the battery and other components.

Next, we need to disconnect the battery by sliding it forward, lifting it up and back, and flicking the connector up. We also need to disconnect the battery antenna cables, video cable, and speaker cables. Carefully lift and unplug each of these cables, making sure not to damage anything in the process. There may also be additional cables for components like the trackpad that need to be disconnected. Keep track of all the screws and components you remove for easier reassembly later on.

Once all the necessary components are disconnected, we can proceed to remove the main board. This may require disconnecting more screws and cables, including those Hidden under other components. Take your time and make sure to remove all the necessary screws before attempting to lift the board. It's also worth mentioning that the heatsink may be attached and require removal as well.

Now that the main board is exposed, we can proceed to replace the faulty charging port. Using a Hakko soldering iron and a solder sucker, we can remove the old port by heating the existing joints and removing the solder. Once removed, we can clean the area and prepare it for the replacement component. The new charging port can now be soldered into place, ensuring a secure connection.

After replacing the charging port, it is important to test the device to ensure that it is functioning properly. Connect the charger, wiggle it around to check for any issues, and make sure it charges and powers up as expected. If everything is working fine, we can proceed to reassemble the laptop.

Begin by reconnecting the cables and screws in the reverse order of removal. Take Care to Align the components correctly and secure them in place. Once everything is connected and secured, put the back cover back on. Make sure to clean any Dust from the inside of the device before closing it up. Finally, tighten the screws and make sure everything is back in its place.

In conclusion, by following these steps and replacing the charging port, you can repair an older Zenbook Duo with a damaged charging port. This guide should also be Relevant to similar models, as they are likely to have similar internal components. Make sure to test the device thoroughly after reassembly to ensure that it is functioning as expected. With some patience and the right tools, you can successfully repair your laptop and avoid the need for an expensive replacement.